Oregon Scientific Fitness Electronics PE326FM User Manual

5.  
6.  
LCD  
3.  
Walk at a normal pace; take at  
least 100 steps.  
burn approximately 300 calories. The  
following diagram will give you some  
basic reference to the calorie  
consumption for people of various  
weights.  
Count up  
timer  
Stride  
distance  
Operating  
temp  
99 hours, 59 minutes,  
59 seconds  
30 to 150 cm  
(11 to 60 inches)  
-10 to 40 °C (14 to 104  
°F)  
-20 to 60 °C (-4 to 140  
°F)  
ADJUSTING THE SETTINGS  
DISTANCE AND CALORIES  
RESET / : Resets display mode  
values to zero, increases value in  
settings  
Shows when batteries are low.  
To open the cover:  
Holding the pedometer upright, grasp the  
clip with one hand and press the COVER  
RELEASE button with the other.  
Total distance = steps taken x average  
step length. Measuring distance correctly  
depends on setting the correct average  
length of individual stride.  
7.  
Belt clip  
Storage temp  
LCD  
Pedometer with Radio  
Model: PE326FM  
Precise calories expended calculations  
require taking into account many factors.  
The PE326FM uses body weight and the  
number of steps taken to give a good  
estimate.  
Batteries  
Battery life  
2 x LR44 1.5V  
6 hours continuous  
radio.  
1 year pedometer only.  
64 x 33 x 42 mm  
(2.52 x 1.30 x 1.65  
inches)  
CLOCK  
1.  
2.  
Press MODE until the STEP mode  
is displayed.  
Press and hold MODE for two  
seconds. The 12-hour value will  
USER MANUAL  
Product size  
(L x W x H)  
INTRODUCTION  
4.  
Adjust sensitivity switch if walking  
speed changes. Repeat steps 2-4  
until accurate reading is obtained.  
WARNINGS  
To set stride length and body weight:  
flash. Press RESET /  
between 12 hour and 24 hour  
format.  
to select  
Thank you for selecting an Oregon  
Scientific™ pedometer (PE326FM).  
This product is designed to give you  
years of service if handled properly.  
Observe the following guidelines:  
1.  
In DIST / TIMER or CAL / TIMER  
mode press and hold MODE for  
two seconds to enter STRIDE /  
WEIGHT display. The stride  
numbers will flash.  
Weight  
34.9 g (1.23 ounces)  
with batteries  
1.  
2.  
3.  
4.  
5.  
Displays when radio is operating  
Displays when batteries are low  
Displays when calories are shown  
Displays when timer is running  
Displays am / pm on a 12 hour  
clock  
Indicating mode displayed:  
STEP displays the number of  
steps taken and the clock  
DIST / TIMER displays the  
distance traveled and the count-up  
timer  
CAL / TIMER displays the  
approximate number of calories  
expended and the count-up timer  
Distance in Km or Miles  
Weight in Kg / Lbs  
Displays when in Timer Mode  
The following conditions may cause  
incorrect reading of steps taken:  
1.  
Keep this manual handy as you use your  
new product. It contains practical step-  
by-step instructions as well as technical  
specifications and warnings you should  
know about.  
Clean the unit with a slightly damp  
cloth and mild detergent.  
Never immerse the unit in water.  
This can cause electrical shock  
and damage the unit.  
Uneven walking pace, such as  
walking in crowded areas or on  
uneven floor.  
Frequent up and down movements,  
such as standing up and/or sitting  
down; running, jumping, going up  
and down stairs etc.  
ABOUT OREGON SCIENTIFIC  
Visit our website  
more about Oregon Scientific products  
such as digital cameras; MP3 players;  
children’s electronic learning products  
and games; projection clocks; health and  
fitness gear; weather stations; and digital  
and conference phones. The website  
also includes contact information for our  
Customer Care department in case you  
need to reach us, as well as frequently  
asked questions and customer  
2.  
6.  
Do not subject the main unit to  
extreme force, shock, or  
fluctuations in temperature or  
humidity.  
Do not tamper with the internal  
components. Doing so will  
terminate the unit’s warranty and  
may cause damage. The unit  
contains no user-serviceable parts.  
Do not mix new and old batteries  
or batteries of different types.  
Do not use rechargeable batteries  
with this product.  
Remove the batteries if storing this  
product for a long period of time.  
Do not scratch the LCD.  
Read this instruction manual  
thoroughly before operating the  
unit.  
KEY FEATURES  
FRONT VIEW  
3.  
4.  
Press MODE, the “hour” digits will  
flash.  
Press RESET /  
to alter hour  
USING THE PEDOMETER  
COUNT-UP TIMER  
value. Press and hold to increase  
the value rapidly.  
2.  
Press RESET /  
until the desired  
length of stride is selected (30 to  
150cm or 11 to 60 inches).  
Press MODE, the weight numbers  
will flash.  
5.  
6.  
Press MODE to confirm the  
change and move on to the next  
setting.  
Repeat 3, 4 to complete setting  
minute and second values.  
The count-up timer will start from zero  
and count to a maximum time of 99  
hours, 59 minutes, and 59 seconds  
(99:59’59”)  
3.  
4.  
7.  
8.  
9.  
downloads.  
Press RESET /  
until desired  
weight setting is reached (30-  
150kg or 65-340lbs).  
10. Stride in Cm or Inches  
We hope you will find all the information  
you need on our website, however if  
you’re in the US and would like to  
contact the Oregon Scientific Customer  
Care department directly, please visit:  
www2.oregonscientific.com/service/defa  
ult.asp  
1.  
In DIST / TIMER or CAL / TIMER  
mode press ST / SP to start the  
timer.  
GETTING STARTED  
5.  
Press MODE to confirm and exit.  
RADIO  
1.  
COVER RELEASE: Press to open  
protective cover  
EARPHONES PLUG  
VOLUME: Slide to increase /  
decrease radio volume  
Battery compartment  
Radio RESET: Press to return to  
default station  
INSULATION TAPE  
To operate radio:  
The built-in FM Radio will automatically  
turn on when earphones are inserted.  
TIP Individual stride-length varies. Input  
an appropriate length for an average  
stride. To determine length of stride walk  
10 paces and divide distance traveled by  
10.  
Before using the device, pull out the  
insulation tape underneath the battery  
cover.  
2.  
3.  
The earphone icon  
Gently remove the earphones to switch  
will appear.  
Do not dispose this product as  
unsorted municipal waste.  
Collection of such waste  
OR  
4.  
5.  
NOTE The unit will not work until the  
tape is pulled out.  
the radio off. The  
icon will disappear.  
Call 1-800-853-8883.  
separately for special treatment is  
necessary.  
6.  
Radio SCAN: Press to scan  
through radio stations  
To scan stations:  
2.  
Press ST / SP again to stop the  
timer.  
BATTERIES  
For international inquiries, please visit:  
www2.oregonscientific.com/about/interna  
tional.asp  
1.  
1.  
Press SCAN to scroll upward  
through frequencies until a  
The contents of this user manual and  
technical specifications are subject to  
change without further notice. Images  
not drawn to scale. The manufacturer  
and its suppliers hold no responsibility to  
you or any other person for any damage  
expenses, lost profits or any other claim  
that arose by using this product.  
INTERIOR  
reception is found.  
To reset the timer to zero, press RESET  
in DIST / TIMER or CAL / TIMER mode.  
2.  
2.  
Press SCAN again to move to the  
next reception.  
EU-DECLARATION OF CONFORMITY  
When the unit reaches 108 MHz  
press Radio RESET to return to  
default frequency (88 MHz).  
Slide the VOL to obtain the  
desired volume level.  
TO VIEW VALUES  
Hereby, Oregon Scientific, declares that  
this pedometer (model PE326FM) is in  
compliance with the essential  
requirements and other relevant  
provisions of EMC directive 89 / 336 / CE  
and LVD directive 73 / 23 / EC.  
MOTION SENSITIVITY  
To view steps taken, distance traveled  
and calories expended:  
Press MODE to enter the desired mode.  
Follow these important procedures to  
adjust the Motion Sensitivity and  
ensure accurate readings:  
3.  
1.  
Correctly position and attached the  
unit to a belt or waistband.  
To change the batteries:  
SPECIFICATIONS  
TIP: When the radio is not in use remove  
earphone from the earphone jack to  
avoid battery drain.  
To reset the values, press RESET /  
STEP mode.  
in  
1.  
2.  
3.  
Gently press and pull the battery  
compartment door.  
Insert 2 x LR44 size 1.5V batteries  
or equivalent.  
Replace the battery compartment  
door.  
TYPE  
Operating  
modes  
Real time  
clock  
DESCRIPTION  
STEP, DIST / TIMER,  
CAL / TIMER  
12 hour / 24 hour  
option with hour /  
minute / second display  
0 to 99,999 steps  
0 to 999.99 km  
A copy of the signed and dated  
Declaration of Conformity is available on  
request via our Oregon Scientific  
Customer Service  
NOTE The total distance and calories  
expended will be cleared along with the  
total steps.  
NOTE Prolonged simultaneous use of  
the EL backlight and FM radio may  
cause batteries to deplete rapidly and  
affect unit performance.  
1.  
2.  
MODE: Toggles between STEP,  
DIST / TIMER and CAL / TIMER  
ST / SP: Starts / Stops timer  
3.  
4.  
: Turns backlight on  
Motion sensitivity switch:  
Increases or decreases unit  
sensitivity  
FITNESS TIPS  
NOTE Protect the environment by taking  
exhausted batteries to authorized  
disposal stations.  
Step counter  
Distance  
traveled  
To keep fit, it generally takes a person  
weighing 60kg to walk 10,000 steps to  
(0 to 999.99 miles)  
2.  
Reset step counter to zero.  
© 2005 Oregon Scientific. All rights reserved.  
 

National Instruments Network Card NI PXI 8250 User Manual
National Mower Lawn Mower HY70OM 8 992 User Manual
Nextar GPS Receiver 43 Q4 User Manual
Nokia Tablet 2520 User Manual
NordicTrack Home Gym NTTL09710 User Manual
Nortel Networks Network Card NN44200 700 User Manual
Onkyo Car Stereo System CS 535 User Manual
Onkyo Stereo Receiver TX DS787 User Manual
Panasonic Network Card 2SC5846 User Manual
Panasonic Vacuum Cleaner MC 4500 User Manual